
/microprocessor-chip-in-circuit-board-85757306-596fa28e6f53ba0011f9135c.jpg)
- Intel desktop board dq45ek install#
- Intel desktop board dq45ek serial#
- Intel desktop board dq45ek series#
Here is a link that I got that info from.
Intel desktop board dq45ek install#
Also the specs for your CPU show that there is no inbuilt graphics, so unless there is a graphics chip on the mobo which seems likely given the connectors you say are there, you will have to install a video card to get an output.
Intel desktop board dq45ek series#
Your CPU should work with a DP45 series chipset however.

I cannot find the DP45CB mobo listed on the Intel site, only the DQ45CB or the DP45SG, therefore perhaps it is an OEM modified board. Thanks in advance to whoever can help or has any input. Trying several places for help and happened to open iFixIt and saw all the new categories, figuring it can't hurt to put it out there. I am cataloging this build to post to YouTube but will also make a guide for here. * tried both even though I knew the 750 wasn't the problem as I tested it and it's double the power of the Dell LiteOn original.

If non-SPD memory is installed, the BIOS will attempt to correctly configure the memory settings, but performance and reliability may be impacted or the DIMMs may not function under the determined frequency. This allows the BIOS to read the SPD data and program the chipset to accurately configure memory settings for optimum performance.
Intel desktop board dq45ek serial#
To be fully compliant with all applicable DDR SDRAM memory specifications, the board should be populated with DIMMs that support the serial presence detect (SPD) data structure. DDR2 800 MHz DIMMs with SPD timings of only 5-5-5 or 6-6-6 (tCL-tRCD-tRP).DDR2 667 MHz DIMMs with SPD timings of only 5-5-5 (tCL-tRCD-tRP).DDR2 800 MHz or DDR2 667 MHz SDRAM DIMMs.Minimum recommended total system memory: 512 MB.8 GB maximum total system memory using DDR2 800 MHz or DDR2 667 MHz DIMMs.Unbuffered, single-sided or double-sided DIMMs with the following restriction: double-sided DIMMs with x16 organization are not supported.1.8 V DDR2 SDRAM DIMMs with gold plated contacts, with the option to raise the voltage to support higher performance DDR2 SDRAM DIMMs.The board has two DIMM sockets and support the following memory features:
